User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 137 System Manual
3.4.2.1.3.2 Creating a VLAN Translation Entry
A VLAN translation entry contains a mapping between the original and translated
VLANs. To create a VLAN translation entry, run the following command:
npu(config-if)# vlan mapping <integer(9|11-100|110-4094)>
<integer(9|11-100|110-4094)>
Specify the original VLAN ID and the translated VLAN ID.
Command
Modes
Interface configuration mode
IMPORTANT
An error may occur if:
 The original and/or translated VLAN ID that you have specified is not within the allowed range.
 The translated VLAN ID that you have specified is already a member VLAN for this port.
 You are trying to create a VLAN translation entry for a VLAN that is not a member of DATA port.
 A VLAN translation mapping already exists for the original VLAN IDs that you have specified.
Command
Syntax
npu(config-if)# vlan mapping <integer(9|11-100|110-4094)> <integer(9|11-100|110-4094)>
Privilege
Level
10