User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 136 System Manual
if the value of the VLAN ID(s) used for data (R3) and (if applicable) for management
traffic in the backbone differs from the value configured for the bearer and (if
applicable) external-management interface, the VLAN ID(s) configured for the IP
interface(s) should be translated accordingly.
Before starting VLAN translation, first enable VLAN translation, and then create
one or more VLAN translation entries.
This section describes the commands for:
 “Enabling/Disabling VLAN Translation” on page 136
 “Creating a VLAN Translation Entry” on page 137
 “Deleting a VLAN Translation Entry” on page 138
3.4.2.1.3.1 Enabling/Disabling VLAN Translation
By default, VLAN translation is disabled. Run the following command to
enable/disable VLAN translation on the DATA (gigabitethernet 0/10) interface:
npu(config-if)# vlan mapping {enable|disable}
IMPORTANT
An error may occur when you run this command:
 For an interface other than the DATA port (0/10).
Command
Syntax
npu(config-if)# vlan mapping {enable|disable}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{enable|disable} Indicates whether VLAN
translation should be enabled
or disabled for this interface.
Mandatory disable
 enable
 disable