User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 134 System Manual
3.4.2.1.2.4 Specifying the port speed
If you have disabled the auto-negotiation feature, you can run the following
command configure the port speed to be used for this physical interface.
npu(config-if)# speed {10 | 100 | 1000}
By default, the port speed for the Fast Ethernet interfaces is 100 Mbps, and for
the Gigabit Ethernet interfaces is 1000 Mbps.
Command
Modes
Interface configuration mode
IMPORTANT
An error may occur if you run this command when:
 Auto-negotiation is enabled.
 The interface does not support the specified speed.
Command
Syntax
npu(config-if)# speed {10 | 100 | 1000}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{10 | 100 | 1000} Indicates the speed, in Mbps,
to be configured for this
physical interface.
A value of 1000 is not
applicable for Fast Ethernet
interfaces.
Mandatory N/A
 10
 100
 1000
Command
Modes
Interface configuration mode