User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 131 System Manual
3.4.2.1.2 Configuring the Properties of the Physical Interface
After you enable the interface configuration mode, you can configure the following
properties for this interface:
 Auto-negotiation mode
 Duplex (full/half) mode
 Port speed
 MTU
This section describes the commands to be used for:
 “Shutting down the interface” on page 132
 “Defining the auto-negotiation mode” on page 132
 “Specifying the Duplex Status” on page 133
 “Specifying the port speed” on page 134
Syntax
Description
Parameter Description Presence Default
Value
Possible Values
<interface-type> Indicates the type of
physical interface (Gigabit
Ethernet or Fast Ethernet)
for which the configuration
mode is to be enabled.
Mandatory N/A
 fastethernet
 gigabitethernet
<interface-id> Indicates the port number
of the physical interface for
which the configuration
mode is to be enabled.
Mandatory N/A Fast Ethernet:
 0/8
Gigabit Ethernet:
 0/9
 0/10
Command
Modes
Global configuration mode