User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing Software Upgrade
4Motion 102 System Manual
3.2.2.1.3 Step 3: Resetting and Booting the NPU Using the Shadow Image
After the shadow image is downloaded to the NPU flash, run the following
command to reboot the NPU with the downloaded shadow image:
npu(config)# reboot from shadow [<shadow image name>]
In the above command, you can specify the shadow image name that is to be used
for NPU reboot. If you do not specify a value for the shadow image name
parameter, the shadow image that was last downloaded is used for rebooting the
NPU.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<shadow
image name>
Denotes the name of the
shadow image that is to be
downloaded to the NPU flash.
The name of this file should
always be suffixed with .tgz.
Mandatory N/A <Valid shadow
image
name>.tgz
Command
Modes
Global configuration mode
NOTE
After you have triggered the download procedure, you can at any time, obtain information about the
download status. For more details, refer to
“Displaying the Download Status Information”
on page 105
.
Command
Syntax
npu(config)# reboot from shadow [<shadow image name>]
Syntax
Description
Parameter Description Presence Default
Value
Possible Value
<shadow
image name>
Denotes the name of the
shadow image that is to be
used for rebooting the NPU.
If you do not specify a value
for this parameter, the last
downloaded shadow image is
used for rebooting the NPU.
Optional N/A Valid shadow
image name