User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 239 System Manual
3.4.12.4 Managing the Context Function
The context function manages the contexts of various authenticated MSs,
including parameters pertaining to context creation and reports. You can specify
the ms-capacity-threshold parameter that is used to define the upper limit for the
number of MSs that can be served by the ASN-GW. Other context function
parameters are configurable only by the vendor.
This section describes the commands to be used for:
 “Configuring the Parameter for the Context Function” on page 239
 “Restoring the Default Configuration Parameter for the Context Function” on
page 240
 “Displaying Configuration Information for the Context Function” on page 240
3.4.12.4.1 Configuring the Parameter for the Context Function
To configure the parameter for the context function, run the following command:
npu(config)# contextfn ms-capacity-threshold <integer (1-3000)>
dpTimerPathRegRsp The period, in milliseconds, within which the NPU should wait for an
acknowledgement for the registration response. If a response is not
received within this period, the NPU retransmits the response.
dpCounterPathRegRspMax The maximum number of times the NPU may retransmit the path response.
pdpTimerPathRegStart Indicates the period, in milliseconds, within which the path registration
procedure is initiated, after the path pre-registration procedure is complete.
If the path registration procedure is not completed within the period
specified by this parameter, the MS is de-registered.
dpTimerMipWaitDhcp The period, in seconds, for allocating the IP address, after the path
registration procedure is complete.
IMPORTANT
An error may occur if you provide an invalid value for the ms-capacity-threshold parameter. Refer to
the syntax description for more information about the appropriate values configuring this parameter.
The ms-capacity-threshold parameter must be specified (the value is optional): The command
npu(config)# contextfn will return an Incomplete Command error.
Command
Syntax
npu(config)# contextfn ms-capacity-threshold <integer (1-3000)>