User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 236 System Manual
 “Displaying Configuration Information for the Data Path Function” on
page 237
3.4.12.3.1 Configuring the Parameter for the Data Path Function
To configure the parameter for the data path function, run the following
command:
npu(config)# datapath throughput-threshold <integer(1-500)>
3.4.12.3.2 Restoring the Default Parameter for the Data Path Function
To restore the default configuration for the data path function, run the following
command:
npu(config)# no datapath [throughput-threshold]
IMPORTANT
An error may occur if you provide an invalid value for the throughput-threshold parameter. Refer to
the syntax description for more information about the appropriate values configuring this parameter.
The throughput-threshold parameter must be specified (the value is optional): The command
npu(config)# datapath will return an Incomplete Command error.
Command
Syntax
npu(config)# datapath throughput-threshold <integer(1-500)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
throughput-thresho
ld <integer(1-500)>
Maximal total throughput in
Mbps via ASN-GW (UL+DL).
Used as threshold for "no
resource" reject and relevant
alarm
Optional 200 1-500
Command
Modes
Global configuration mode