User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 230 System Manual
3.4.11.3 Displaying Configuration Information for BTS Load
Balancing Pools
To display configuration information of a Load Balancing Pool, run the following
command:
For pool 1: npu# show loadbalancePool1IP
For pool 2: npu# show loadbalancePool2IP
3.4.12 Configuring the ASN-GW Functionality
The ASN-GW functionality indicates that the NPU executes the following
functions:
Command
Syntax
npu# show loadbalancePool1IP
npu# show loadbalancePool2IP
Privilege
Level
1
Display
Format
AsnGw Ip:<ip address>
(up to 10 entries)
or:
No IP in pool
Command
Modes
Global command mode
IMPORTANT
Execute the procedures described in this section only if you are operating the NPU in the ASN-GW
mode. Skip this section if you are operating the NPU in the Transparent mode.