User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 221 System Manual
3.4.10.1.4 Terminating the ACL Configuration Mode
To terminate the standard ACL configuration mode and return to the global
configuration mode, run the following command:
npu(config-std-nacl)# exit
To exit the extended ACL configuration mode and return to the global
configuration mode, run the following command:
npu(config-ext-nacl)# exit
3.4.10.2 Deleting an ACL
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{ any | host
<src-ip-address> |
<src-ip-address>
<mask> }
Indicates the source IP
address/subnet for which the
Permit/Deny rule for incoming
ICMP traffic is to be deleted.
Mandatory N/A For details
Table 3-22
{ any | host
<dest-ip-address>
|
<dest-ip-address>
<mask> }
Indicates the destination IP
address/subnet for which the
Permit/Deny rule for ICMP
traffic is to be deleted.
Optional any For details
Table 3-22
Command
Modes
Extended ACL configuration mode
Command
Syntax
npu(config-std-nacl)# exit
npu(config-ext-nacl) # exit
Privilege
Level
10
Command
Modes
Standard/Extended ACL configuration mode
To delete an ACL: