User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 217 System Manual
3.4.10.1.3.3 Configuring Permit/Deny Rules for ICMP Traffic
After you have created an ACL, you can configure Permit/Deny rules for ICMP
traffic from/to specific a source and destination IP address/subnet.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
any | host
<src-ip-address> |
<src-ip-address>
<src-mask>
Indicates the source host for
which the Permit/Deny rule
for incoming TCP/UDP traffic
is to be deleted.
Mandatory N/A For details,
refer
Table 3-21
[{gt <port-number
(1-65535)> | lt
<port-number
(1-65535)> |eq
<port-number
(1-65535)> | range
<port-number
(1-65535)>
<port-number
(1-65535)>}]
Indicates the source port for
which the Permit/Deny rule
for incoming TCP/UDP traffic
is to be deleted.
Optional 1-65535 For details,
refer
Table 3-21
any | host
<dest-ip-address>
|
<dest-ip-address>
<dest-mask>
Indicates the NPU IP
address/subnet for which the
Permit/Deny rule for
TCP/UDP traffic is to be
deleted.
Mandatory N/A For details,
refer
Table 3-21
[{gt <port-number
(1-65535)> | lt
<port-number
(1-65535)> |eq
<port-number
(1-65535)> | range
<port-number
(1-65535)>
<port-number
(1-65535)>}]
Indicates the NPU interface
port for which the
Permit/Deny rule for incoming
TCP/UDP traffic is to be
deleted.
Optional 1-65535 For details,
refer
Table 3-21
Command
Modes
Extended ACL configuration mode