User Manual
Chapter 3 - Operation and Administration of the Macro BTS Managing Software Upgrade
4Motion 110 System Manual
Specify the slot ID if you want to map the image to a specific AU slot. Specify
default if you want to use this as the default mapping for all AU cards for which
a mapping does not exist.
3.2.3.1.4 Step 4: Downloading the Image to the AU Flash
The AU flash can store two AU images: shadow and operational. The operational
image is the image that is currently mapped to the AU slot, and is used for booting
the AU when the AU is reset. The shadow image is the image that is downloaded
from the NPU flash.
IMPORTANT
Always create a default AU-to-image mapping to be used for booting one or more AU cards, before
inserting/re-inserting the AU card.
Command
Syntax
npu(config)# map au {<au slot-id|default>} <image name>
Syntax
Description
Parameter Description Presence Default
Value
Possible Value
<au
slot-id|default>
Indicates the AU to which the
image is to be mapped.
Mandatory N/A
1, 2, 3, 4, 7,
8, 9 (valid
slot ID)
default: if
you want to
create a
default
AU-to-imag
e mapping
that can be
used by all
AUs for
which a
mapping
does not
exist.
<image name> Denotes the name of the
image to be mapped to the
AU slot.
Mandatory N/A Valid image
name
Command
Modes
Global configuration mode