User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 347 System Manual
3.4.12.11.4.6.2Enabling the Destination Address and Configuring the Address Mask
Run the following command to enable the destination address classifier and
configure the address mask for the destination address.
npu(config-clsfrule-dstaddr)# config [addr-enable] [addr-mask
<value>]
You can also run this command to enable a destination address that is currently
disabled. For details, refer to “Disabling the Destination Address” on page 348.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ipv4addr> Denotes the IPv4 address of
the destination address for
which the configuration mode
is to be enabled. The
destination address
configuration mode is
automatically enabled.
Mandatory N/A Valid IP
Address
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
An error may occur if you provide an invalid address mask. Refer the syntax description for more
information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule-dstaddr)# config [addr-enable] [addr-mask <value>]
Privilege
Level
10