User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 346 System Manual
npu(config-clsfrule-dstaddr)# config addr-enable addr-mask
0.0.255.255
npu(config-clsfrule-srcaddr)# exit
3.4.12.11.4.6.1Enabling the Destination Address Configuration Mode\ Creating a New
Destination Address
To configure the parameters for a destination address, first enable the destination
address configuration mode. Run the following command to enable the
destination address configuration mode. This command also creates the new
destination address classifier.
npu(config-clsfrule)# dstaddr <ipv4addr>
The configuration mode for the newly created destination address is automatically
enabled, after which you can execute any of the following tasks:
 Configure the address mask (refer to Section 3.4.12.11.4.6.2)k
 Disable the destination address (refer to Section 3.4.12.11.4.6.3)
After you execute these tasks, you can terminate the destination address
configuration mode (refer to Section 3.4.12.11.4.6.4) and return to the
classification rules configuration mode.
IMPORTANT
An error may occur if you provide an invalid destination IP address. Refer the syntax description for
more information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# dstaddr <ipv4addr>
Privilege
Level
10