User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 345 System Manual
3.4.12.11.4.6 Managing Destination Address Configuration for the L3 Classification Rule
Classification rules can classify the packet, based on the destination address of
the packet. You can configure the value of destination address for a given
classification rule.
1 Enable the destination address configuration mode (refer to
Section 3.4.12.11.4.6.1)
2 You can now execute any of the following tasks:
» Configure the address mask (refer to Section 3.4.12.11.4.6.2)
» Disable the destination address (refer to Section 3.4.12.11.4.6.3)
3 Terminate the destination address configuration mode (refer to
Section 3.4.12.11.4.6.4)
In addition, you can, at any time, delete an existing destination address (refer to
Section 3.4.12.11.4.6.5).
The following example illustrates the (sequence of) commands for enabling the
destination address configuration mode, enabling the destination address
classifier, configuring the address mask, and then terminating the destination
address configuration mode:
npu(config-clsfrule)# dstaddr 10.203.155.22
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<ip-Addr>] Denotes the IPv4 address of
the source address that you
want to delete from a
classification rule.
Optional N/A Valid IP
Address
Command
Modes
L3 Classification rules configuration mode
To configure a destination address classifier: