User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 344 System Manual
3.4.12.11.4.5.4Terminating the Source Address Configuration Mode
Run the following command to terminate the source address configuration mode:
npu(config-clsfrule-srcaddr)# exit
3.4.12.11.4.5.5Deleting Source Address
You can, at any time, run the following command to delete the source address
classifier:
npu(config-clsfrule)# no srcaddr [<ip-Addr>]
Command
Syntax
npu(config-clsfrule-srcaddr)# no addr-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-source address configuration mode
Command
Syntax
npu(config-clsfrule-srcaddr)# exit
Privilege
Level
10
Command
Modes
L3 Classification rule-source address configuration mode
Command
Syntax
npu(config-clsfrule)# no srcaddr [<ip-Addr>]
Privilege
Level
10