User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 343 System Manual
3.4.12.11.4.5.3Disabling the Source Address
You can run the following command to disable the source address that is
currently enabled:
npu(config-clsfrule-srcaddr)# no addr-enable
Command
Syntax
npu(config-clsfrule-srcaddr)# config [addr-enable] [addr-mask <value>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default Value Possible
Values
[addr-enable] Indicates that the use of
the associated source
address is enabled for
the classification rule
that you are configuring.
If the use of this address
is disabled, the
associated source
address is ignored while
classifying the packet.
Optional By default, the
use of the
associated
source address
is disabled.
The
presence/abse
nce of this flag
indicates that
the use of the
associated
source address
is
enabled/disabl
ed.
[addr-mask
<value>]
Denotes the mask field
that is used to specify a
range of source
addresses.
Optional 255.255.255.25
5
Valid address
mask
Command
Modes
L3 Classification rules-source address configuration mode
IMPORTANT
To enable this source address, run the following command:
npu(config-clsfrule-srcaddr)# config [addr-enable] [addr-mask <value>]
For details, refer to
“Enabling the Source Address and Configuring the Address
Mask” on page 342
.