User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 340 System Manual
npu(config-clsfrule-protocol)# exit
3.4.12.11.4.4.5Deleting the IP Protocol Classifier
You can, at any time, run the following command to delete the protocol classifier:
npu(config-clsfrule)# no ip-protocol
3.4.12.11.4.5 Managing Source Address Configuration for the L3 Classification Rule
Classification rules can classify the packet, based on the source address of the
packet. You can configure the value of source address for a given classification
rule.
1 Enable the source address configuration mode (refer to
Section 3.4.12.11.4.5.1)
Command
Syntax
npu(config-clsfrule-protocol)# exit
Privilege
Level
10
Command
Modes
L3 Classification rule-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule)# no ip-protocol
Privilege
Level
10
Command
Modes
L3 Classification rule-IP protocol configuration mode
To configure a source address classifier: