User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 339 System Manual
3.4.12.11.4.4.3Disabling Protocol Lists
After enabling the protocol configuration mode, run the following command to
disable IP protocol classification:
npu(config-clsfrule-protocol)# no protocol-enable <number of
protocols(1)> <protocol>
3.4.12.11.4.4.4Terminating the Protocol Configuration Mode
Run the following command to terminate the IP protocol configuration mode:
<protocol> Indicates the IP protocol to be
enabled. In the current
release, only one protocol
can be enabled per
classification rule.
Mandatory N/A 0-255 (Using
standard IANA
protocol
values)
Command
Modes
L3 Classification rules-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule-protocol)# no protocol-enable <number of protocols(1)> <protocol>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<number of
protocols(1)>
Indicates the number of
protocol lists to be disabled.
In the current release, only
one protocol can be enabled
per classification rule.
Mandatory N/A 1
<protocol> Indicates the protocol to be
disabled.
Mandatory N/A 0-255
Command
Modes
L3 Classification rules-IP protocol configuration mode