User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 258 System Manual
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer to the syntax
description for more information about the appropriate values and format for configuring these
parameters.
At least one parameter must be specified (the value is optional): The command
npu(config-srvcif-vlan)# config will return an Incomplete Command error.
Command
Syntax
npu(config-srvcif-vlan)# config ([descr <string>] [vlan-id <size(1-9|11-4094>]
[dflt-gw-ip <ip address> <mask>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
descr <string> Aa description of the service
interface.
Optional null String (up to 70
characters)
vlan-id
<size(1-9|11-4094
>]
A Service Interface VLAN ID
shall not conflict with other
instances of Service Interface
VLAN ID and VLAN IDs of
Bearer, Local-Management,
External-Management and
AU Maintenance interfaces.
Shall also not conflict with
CVID of any transparent MS
with L2 service.
Must be set to a valid value
other than the default (0). The
VLAN ID of an existing
Service Interface cannot be
changed.
Optional 0 1-9, 11-4094