User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 338 System Manual
3.4.12.11.4.4.2Enabling IP Protocol Classifier
After enabling the IP protocol configuration mode, run the following command to
enable the IP protocol classifier and define the Protocol number:
npu(config-clsfrule-protocol)# protocol-enable <number of
protocols(1)> <protocol>
Command
Syntax
npu(config-clsfrule)# ip-protocol
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
If source port range (see Section 3.4.12.11.4.7.2) or destination port range (see
Section 3.4.12.11.4.8.2) is enabled, then:
IP protocol (protocol-enable) must be set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
Command
Syntax
npu(config-clsfrule-protocol)# protocol-enable <number of protocols(1)> <protocol>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<number of
protocols(1)>
Indicates the number of
protocol lists to be enabled. In
the current release, only one
protocol can be enabled per
classification rule.
Mandatory N/A 1