User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 337 System Manual
3.4.12.11.4.4 Managing IP Protocol Configuration for the L3 Classification Rule
L3 classification rules can classify the packet, based on the value of IP protocol
field. You can configure the value of IP protocol for a given classification rule.
1 Enable the IP protocol configuration mode (refer to Section 3.4.12.11.4.4.1)
2 Enable/disable IP protocol classification (refer to Section 3.4.12.11.4.4.2
anReclassifiedSection 3.4.12.11.4.4.3)
3 Terminate the protocol configuration mode (refer to Section 3.4.12.11.4.4.4)
In addition, you can, at any time, delete an existing IP protocol classifier (refer to
Section 3.4.12.11.4.4.5).
The following example illustrates the sequence of commands for enabling the IP
protocol configuration mode, enabling IP protocol 100, and then terminating the
protocol lists configuration mode:
npu(config-clsfrule)# ip-protocol
npu(config-clsfrule-protocol)# protocol-enable 1 100
npu(config-clsfrule-protocol)# exit
3.4.12.11.4.4.1Enabling the IP Protocol Configuration Mode
Run the following command to enable the IP protocol configuration mode.
npu(config-clsfrule)# ip-protocol
You can now enable or disable the IP protocol (refer to Section 3.4.12.11.4.4.2 and
Section 3.4.12.11.4.4.3).
Command
Syntax
npu(config-clsfrule)# no [priority] [iptos-low] [iptos-high] [iptos-mask] [iptos-enable]
[phs-rulename]
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode
To configure IP protocol classifier: