User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 257 System Manual
3.4.12.8.2.2 Configuring Parameters for VLAN Service Interface
After enabling the VLAN Service Interface configuration mode, run the following
command to configure the VLAN service interface parameters:
This command shall configure one or more parameters of the VLAN Service
Interface.
npu(config-srvcif-vlan)# config ([descr <string>] [vlan-id <size(1-9|11-4094>]
[dflt-gw-ip <ipaddress> <mask>]
[srcaddr
<ip4addr>]
The source IP address that
indicates the point of
origination of the tunnel for
the service interface.
Must be set to the same
address as the NPU Bearer
IP Address.
Optional 0.0.0.0 IP Address of
Bearer
Interface.
{dstaddr
<ipv4addr>}
The destination IP address
that indicates the point of
termination of the tunnel for
the service interface.
Must be set to a valid IP
address. The destination IP
address of an existing
Service Interface (if already
configured to a valid value)
cannot be changed.
Optional 0.0.0.0 Valid IP
Address.
[chksm] Indicates that end-to-end
checksumming mechanism
on ServiceTunnel Interface is
enabled.
Optional By
default,
this
feature
is
disabled.
The
presence/abse
nce of this flag
indicates that
this feature is
enabled/
disabled.
Command
Modes
IP-IP Service Interface configuration mode