User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 256 System Manual
3.4.12.8.2 Configuring Service Interface Parameters
This section describes the commands for:
 “Configuring Parameters for IP-IP Service Interface” on page 256
 “Configuring Parameters for VLAN Service Interface” on page 257
3.4.12.8.2.1 Configuring Parameters for IP-IP Service Interface
After enabling the IP-IP Service Interface configuration mode, run the following
command to configure the IP-IP service interface parameters:
This command shall configure one or more parameters of the IP-IP Service
Interface.
npu(config-srvcif-ipip)# config tunnel ([descr <string>] [srcaddr <ip4addr>]
{dstaddr <ipv4addr>} [chksm])
Command
Modes
Global configuration mode
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer to the syntax
description for more information about the appropriate values and format for configuring these
parameters.
At least one parameter must be specified (the value is optional): The command
npu(config-srvcif-ip-ip)# config tunnel will return an Incomplete Command error.
Command
Syntax
npu(config-srvcif-ip-ip)# config tunnel ([descr <string>] [srcaddr <ip4addr>]
{dstaddr <ipv4addr>} [chksm])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[descr <string>] A description of the Service
Interface.
Optional null String (up to 70
characters)