User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 314 System Manual
3.4.12.11.3.2 Enabling/Disabling the Service Profile
After enabling the service profile configuration mode, run the following command
to enable this service profile:
npu(config-srvcprfl)# config profile-enable
A service profile can be enabled only if at least one service flow is configured.
To disable this service profile, run the following command:
npu(config-srvcprfl)# no profile-enable
The default mode is Disabled.
3.4.12.11.3.3 Configuring Service Flows
Service flows are unidirectional stream of packets, either in the downlink or
uplink direction, associated with a certain set of QoS requirements such as
maximum latency and minimum rate. Based on certain classification rules,
service flows are transported over the R1 air interface in 802.16e connections,
identified by connection IDs, and identified by GRE keys over the R6 interface in
GRE tunnels. In addition, the ASN-GW can mark outgoing traffic in the R3
interface for further QoS processing within the CSN.
Command
Modes
Global configuration mode
NOTE
You can display configuration information for specific or all service profiles. For details, refer to
Section 3.4.12.11.3.5.
Command
Syntax
npu(config-srvcprfl)# config profile enable
npu(config-srvcprfl)# no profile enable
Privilege
Level
10
Command
Modes
Service profile configuration mode