User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 310 System Manual
3.4.12.11 Configuring the Service Flow Authorization Functionality
The Service Flow Authorization (SFA) functionality handles creation/
maintenance of pre-provisioned service flows for MS. It maps the AAA parameters
(service profile name) received from the AAA server to pre-configured
WiMAX-specific QoS parameters in the NPU. The SFA functionality enables you to
configure multiple service profiles with multiple service flows and classification
rules.
This section describes the commands to be used for:
 “Configuring the SFA PHS Functionality” on page 310
 “Displaying Configuration Information for the SFA PHS Functionality” on
page 311
 “Configuring Service Profiles” on page 311
 “Configuring Classification Rules” on page 330
3.4.12.11.1 Configuring the SFA PHS Functionality
To configure the SFA functionality with respect to PHS Rules, run the following
command:
To enable PHS: npu(config)# sfa phs-enable
To disable PHS: npu(config)# no sfa phs-enable
The default configuration is PHS Disable.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<grp-alias>] Denotes the group-alias for
which the service group to be
displayed.
If no grp-alias is specified, the
parameters of all service
groups will be displayed.
Optional N/A String
Display
Format
According to Service Group type and (for IP Service Group) the configured DHCP mode.