User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 255 System Manual
After enabling the configuration mode for a Service Interface you can execute any
of the following tasks:
 Configure one or more of the Service Interface parameters (refer to
Section 3.4.12.8.2)
 Restore the default values of non-mandatory parameters of the Service
Interface (refer to Section 3.4.12.8.3)
After executing the above tasks, you can terminate the Service Interface
configuration mode (refer to Section 3.4.12.8.4) and return to the global
configuration mode.
NOTE
The Bearer IP Interface (refer to “Configuring IP interfaces” on page 143) must be
configured prior to creating IP-IP or VLAN service interfaces.
Command
Syntax
npu(config)# srvc-intf [<string>] [{IP-IP|VLAN|QinQ}]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<string>]
The Service Interface alias of
the Service Interface for
which you want to enable the
configuration mode. If you
want to create a new Service
Interface, specify a new alias
and define the type of service
interface (see below).
Mandatory N/A String (1 to 30
characters)
[{IP-IP|VLAN
|QinQ}]
The Service Interface’s type. Optional IP-IP
 IP-IP
 VLAN
 QinQ