User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 308 System Manual
3.4.12.10.8 Terminating the Service Group Configuration Mode
Run the following command to terminate the service group configuration mode:
npu(config-srvcgrp)# exit
npu(config-srvcgrp-VPWS)# exit
npu(config-srvcgrp-VPWS-Mapped)# exit
3.4.12.10.9 Deleting a Service Group
You can, at any time, run the following command to delete a service group:
npu(config)# no srvc-grp <grp-alias>
vid-map-range-end
vlan-id
<size(1-4094)>
The start value of the range of
VLAN IDs for mapping.
Cannot be lower than
vid-map-range-start vlan-id
None of the value within the
range shall overlap with any
existing infrastructure (host
interfaces) VLAN IDs. None
of the value within the range
shall overlap with VID
mapping ranges of other
existing Service Groups
Mandatory N/A 1-4094
Command
Modes
VPWS-Mapped Service group configuration mode
Command
Syntax
npu(config-srvcgrp)# exit
npu(config-srvcgrp-VPWS)# exit
npu(config-srvcgrp-VPWS-Mapped)# exit
Privilege
Level
10
Command
Modes
IP/VPWS-Transparent/VPWS-QinQ/VPWS-Mapped Service group configuration mode