User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 306 System Manual
3.4.12.10.7.2 Configuring the VID Map Range Parameters of a VPWS-Mapped Service
Group
run the following commands to configure the vid-map-range parameters for the
service group:
{acct {none|time}} The Accounting mode for the
service interface:
none: No accounting support.
time: The ASN-GW sends
RADIUS Accounting
Start/Stop Requests. The
ASN-GW also sends Interim
Accounting requests to AAA
server using RADIUS
Accounting Interim messages
on a preconfigured or
negotiated interval. AAA
server can send negotiated
time interval in
Access-Accept message. If
ASN GW defined value (see
acctInterimTmr below) is zero
and there is no
Acct-Interim-Interval in
Access Accept, interim
updates should be
deactivated.
Optional time
 none
 time
[acctInterimTmr
<integer(0|5-1600)
>]
Applicable only if acct (see
above) mode is set to time.
The default interval in
minutes for Accounting
Interim reports to be used if
Acct-Interim-Interval is not
received from the AAA server.
Value “0” means interim
reports are deactivated
unless Acct-Interim-Interval is
sent by the AAA server in
Access Accept messages.
Optional 5
 0
 5-1600
Command
Modes
VPWS-Mapped Service group configuration mode