User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration

4Motion 300 System Manual

3.4.12.10.4.4.3Removing the DHCP Relay suboption values

Run the following command to remove one, several or all of the Suboption values

configured by the user for DHCP Option 82.

npu(config-srvcgrp-dhcprelay-opt82)# no [Subopt1value] [Subopt2value]

[Subopt6value] [Subopt7value]

[{Subopt7value

[service-type]

[vendor-specific]

[session-timeout]}]

Configures the suboption 7 of

DHCP option 82.

Allows enabling/disabling the

use of suboption 7 by

specifying it. In addition,

allows enabling/disabling the

following attributes (by

specifying attributes to be

enabled) if suboption 7 is

enabled:

 service-type (attribute 6)

 vendor-specific (attribute

26)

 session-timeout (attribute

27)

Optional

[{EnableUnicast|Di

sableUnicast}])

Indicates whether the

Unicast parameter is

enabled or disabled.

Optional Disable

 Enable

 Disable

Command

Mode

Service group-DHCP relay-option 82 configuration mode

Command

Syntax

npu(config-srvcgrp-dhcprelay-opt82)# no [Subopt1value] [Subopt2value] [Subopt6value]

[Subopt7value]

Privilege

Level