User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 296 System Manual
3.4.12.10.4.4.2Configuring the DHCP Relay Option 82 Parameters
If Option 82 for the DHCP Relay is enabled, run the following command to
configure suboptions of option 82 of DHCP messages:
npu(config-srvcgrp-dhcprelay-Opt82)# config ([Subopt1value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|asciiMsID|asciiBsID|asc
iiBsMac|AsciiFrStrng <string(32)>|BinFrStrng <string(32)>}] [Subopt2value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|asciiMsID|asciiBsID|asc
iiBsMac|AsciiFrStrng <string(32)>|BinFrStrng <string(32)>}] [Subopt6value
{Default|MSID|BSID|NASID|NASIP|Full-NAI|Domain|AsciiFrStrng
<string(32)>|BinFrStrng <string(32)>}] [{Subopt7value [service-type]
[vendor-specific] [session-timeout]}] [{EnableUnicast|DisableUnicast}])
IMPORTANT
An error may occur if you provide an invalid value for the DHCP server address. Refer to the syntax
description for more information about the appropriate values and format for configuring this
parameters.
Command
Syntax
npu(config-srvcgrp-dhcprelay)# config ([server-addr <ipV4Addr>]
[{
EnableOpt82|DisableOpt82}])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[server-addr
<ipv4addr>]
Denotes the IP address of the
external DHCP server. Must
be configured to a valid IP
address.
Optional 0.0.0.0 Valid IP
Address
[{EnableOpt82|Dis
ableOpt82}]
Denotes whether DHCP
option 82 is enabled or
disabled.
Optional Disable
Opt82
 EnableOpt82
 DisableOpt8
2
Command
Modes
Service group-DHCP relay configuration mode