User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 289 System Manual
3.4.12.10.4.2.4Deleting Exclude IP Addresses for the DHCP Server
Run the following command to delete one or several excluded IP addresses for the
DHCP server:
npu(config-srvcgrp-dhcpserver)# no exclude-addr <no. of Addrs
(1-9)> <ipv4addr> [<ipv4addr>] …
Run the following command (without specifying the parameters) to delete all
excluded IP addresses for the DHCP server:
npu(config-srvcgrp-dhcpserver)# no exclude-addr
The deleted exclude IP addresses are no longer excluded when the DHCP server
allocates the IP addresses. That is, the server may allocate these IP addresses to
the MS.
Command
Syntax
npu(config-srvcgrp-dhcpserver)# exclude-addr <no. of Addrs (1-9)> <ipv4addr> [<ipv4addr>]
….
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<no. of Addrs
(1-9)>
The number of IP addresses
to be excluded
Mandatory N/A 1-9
<ipv4addr> Denotes the exclude IP
address that will not be
assigned to an MS by the
DHCP server.
The number of IP address
entries must match the value
defined by the no. of Addrs
parameter.
Mandatory N/A Valid IP
address
Command
Modes
Service group-DCHP server configuration mode
Command
Syntax
npu(config-srvcgrp-dhcpserver)# no exclude-addr
no. of Addrs (1-9)> <ipv4addr>
[<ipv4addr>] …