User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 284 System Manual
3.4.12.10.4.2 Configuring the DHCP Server
After enabling the service group operation mode for the DHCP server, you can
execute any of the following tasks:
“Configuring DHCP Server Parameters” on page 284
“Restoring Configuration Parameters for the DHCP Server” on page 288
“Configuring Exclude IP Addresses for the DHCP Server” on page 288
“Deleting Exclude IP Addresses for the DHCP Server” on page 289
3.4.12.10.4.2.1Configuring DHCP Server Parameters
Run the following command to configure the DHCP server:
npu(config-srvcgrp-dhcpserver)# config ([pool-minaddr <string>]
[pool-maxaddr <string>] [pool-subnet <string>] [dflt-gwaddr
<string>] [lease-interval <integer(24-4294967295)>]
[renew-interval <integer>] [rebind-interval <integer>]
[dnssrvr-addr <string>] [offerreuse-holdtime <integer>] [opt60
<string(30)>] [opt43 {[Name <string(64)>] [Value <string(64)>]}]
[Sname <string(64)>] [File <string(128)>] [dnssrvr-addr2 <string>])
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{server|proxy|relay
}
Indicates whether the service
group operation mode is to be
enabled for the DHCP server,
proxy or relay.
Mandatory N/A
server
proxy
relay
Command
Modes
Service group configuration mode
NOTE
Before executing these tasks, ensure that you have enabled the DHCP server configuration mode.
For details, refer to
“Enabling the Service Group Operation Mode for DHCP
Server//Proxy/Relay” on page 283
.