User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 281 System Manual
{acct
{none|time|volume
Time}}
The Accounting mode for the
service interface:
none: No accounting support.
time: The ASN-GW send
RADIUS Accounting
Start/Stop Requests. The
ASN-GW shall also send
Interim Accounting requests
to AAA server using RADIUS
Accounting Interim messages
on a preconfigured or
negotiated interval. AAA
server can send negotiated
time interval in
Access-Accept message. If
ASN GW defined value (see
acctInterimTmr below) is zero
and there is no
Acct-Interim-Interval in
Access Accept, interim
updates should be
deactivated.
volumeTime: Same as for
time option above. In
addition, this mode supports
postpaid accounting by
supporting IP Session
Volume Based Accounting.
The ASN-GW will report the
cumulative volume counters
for each MS IP Session. The
counters will be collected per
MS Service Flow and will be
cumulated in order to get the
MS IP Session counters.
Optional time
 none
 time
 volumeTime
{ms-loop {enable|
disable}}
Denotes whether MS
loopback (direct
communication between two
MSs belonging to the same
service group) is enabled or
disabled for the service
interface
Optional Disable
 Enable
 Disable