User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 280 System Manual
[waitdhcp-holdtime
<timeout>]
Denotes the period, in
seconds, for which the NPU
waits for an IP address
allocation trigger (MIP
registration request / DHCP
discover) from the MS.
If you specify the value of this
parameter as 0, no timer is
started and the NPU will wait
infinitely for the IP address
allocation trigger.
Optional 0 0-86400
[dhcp-ownaddr
<ipv4addr>]
Denotes the IPv4 address of
the DHCP server/ relay/
proxy.
Must be unique in the
network.
For a service group using a
VLAN service interface,
should be in same subnet
with the Default Gateway
configured for the service
interface associated with the
service group. Subnet mask
is taken as the default subnet
mask i.e 255.255.255.0.
Note: In DHCP Server mode,
the DHCP server IP address
must be in the same subnet
but outside the range
allocated for users address
pool as provisioned in the
DHCP Server.
Mandatory N/A Valid IP
Address
{server|proxy|relay
}
Mode of IP address allocation
used for subscribers: DHCP
Server/ Proxy/ Relay.
Mandatory N/A
 dhcp-server
 dhcp-proxy
 dhcp-relay