User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 279 System Manual
{server|proxy|relay} |{[<acct (none|time|volumeTime)>]}|{[<ms-loop
(enable|disable)>] | [acctInterimTmr <integer(0|5-1600)>]}
This commands comprises 5 sub-commands:
1 npu(config-srvcgrp)# config {[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]}
2 npu(config-srvcgrp)# config {server|proxy|relay}
3 npu(config-srvcgrp)# config {[<acct (none|time|volumeTime)>]}
4 npu(config-srvcgrp)# config {[<ms-loop (enable|disable)>]}
5 npu(config-srvcgrp)# config {[acctInterimTmr <integer(0|5-1600)>]}
NOTE
You can display configuration information for the service group. For details, refer to
Section 3.4.12.11.2.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-srvcgrp)# config {{[srvcif-alias <service interface>] [waitdhcp-holdtime <timeout>]
[dhcp-ownaddr <ipv4addr>]} | {server|proxy|relay} |{[<acct (none|time|volumeTime)>]}|{[<ms-loop
(enable|disable)>] | [acctInterimTmr <integer(0|5-1600)>]}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[srvcif-alias
<service
interface>]
Denotes the pre-defined IP or
VLAN service interface alias
to be used as the data path
for traffic towards the core
network.
Note that a Service Interface
alias can be associated only
to a single Service Group.
Mandatory N/A String