User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 276 System Manual
 Associated with a separate service IP or VLAN service interface.
 Configured as any one of the following:
» DHCP server that allocates an IP address to the MS from the local pool (in
the non-HA mode).
» DHCP relay that obtains the IP address using an external DHCP server (in
the non-HA mode).
» DHCP proxy for either of the following boot modes:
◊ Non-HA mode: The DHCP proxy assigns the MS the IP address that was
received from AAA in the MS profile (in FRAMED-IP attribute or R3
Descriptors) or
◊ HA mode: The DHCP proxy assigns the MS, the IP address received in
the MS profile or obtains the IP address from HA using the mobile IP.
1 Enable the service group configuration mode (refer to Section 3.4.12.10.1)
2 You can now execute any of the following tasks:
» Configure the common parameters of an IP service group (refer to
Section 3.4.12.10.2)
» Enable/Disable the VLAN Interface of an IP Service Group (refer to
Section 3.4.12.10.3)
» Enable the service group DHCP operation mode and configure the DHCP
server/proxy/relay-specific parameters (refer to Section 3.4.12.10.4)
» Configure the parameters of a VPWS-Transparent Service Group (refer to
Section 3.4.12.10.5)
» Configure the parameters of a VPWS-QinQ Service Group (refer to
Section 3.4.12.10.6)
» Configure the parameters of a VPWS-Mapped Service Group (refer to
Section 3.4.12.10.7)
To configure a service group: