User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 274 System Manual
3.4.12.9.2.3 Displaying Global RADIUS Configuration Parameters
To display global RADIUS configuration parameters used for all AAA clients, run
the following command:
npu# show radius
NOTE
Refer Section 3.4.12.9.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no radius
[accessreq-retries] [accessreq-interval] [nasid] [timezone-offset] [mtu]
Privilege
Level
10
Command
Modes
Global configuration mode
Command
Syntax
npu# show radius
Privilege
Level
1
Display
Format
TimeOut <value>
accessReq-retries <value>
NAS-ID <value>
TimeZone Offset <value>
framed MtuSize <value>
Profile AtrbtType <value>
alrmAaaSwitchoverRetryFailThrshld <value>
VLAN Bit Alignment <value>
Command
Modes
Global command mode