User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 273 System Manual
3.4.12.9.2.2 Restoring the Default Global RADIUS Configuration Parameters
To restore the default global RADIUS configuration used for AAA clients, run the
following command:
npu(config)# no radius [accessreq-retries] [accessreq-interval]
[nasid] [timezone-offset] [mtu]
[alrmAaaSwitchov
erRetryFailThrshld
(1-250)>]
Threshold to set alarm when
the number of AAA
switchover "unsuccessful
access to primary +
secondary" failed events for a
measured period (PM interval
of 15 minutes) exceeds the
provisioned number.
Optional 250 1 - 250
[vlan-classf-bit-alig
n {msbShift | lsb}]
Defines how to transfer VLAN
ID between R3 and R6:
If msbShift is selected:
a. When transferring classifier
VID value from R3 side to R6
side, the binary value of the
12 least significant bits in R3
TLV will be copied and pasted
as most significant bits in R6
TLV.
b. When transferring classifier
VID value from R6 to R3, the
binary value of the 12 the
most significant bits in R6
TLV will be copied and pasted
as the 12 least significant bits
in R3 TLV.
if lsb is selected: The whole
16 bit value of the relevant
TLV will be transferred
without any change when
transferring classifier VID
value from R3 side to R6 side
and from R6 to R3.
Optional msbShift
 msbShift
 lsb
Command
Modes
Global configuration mode