User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 271 System Manual
In addition to configurable parameters, the currently Active AAA server
(Primary/Alternate) is also displayed.
3.4.12.9.2 Managing Global RADIUS Configuration Parameters
Global RADIUS configuration parameters for AAA clients determine how AAA
clients should send access requests. This section describes the commands to be
used for:
 “Configuring Global RADIUS Parameters” on page 271
 “Restoring the Default Global RADIUS Configuration Parameters” on page 273
 “Displaying Global RADIUS Configuration Parameters” on page 274
3.4.12.9.2.1 Configuring Global RADIUS Parameters
To configure the global RADIUS configuration parameters to be used for all AAA
clients, run the following command:
npu(config)# radius <[accessreq-retries <retransmissions>]
[accessreq-interval <timeout>] [nasid <nas-identifier>]
[timezone-offset <time-offset(0-86400)>] [mtu <framed mtu
size(1020-2000)>][RadiusAtrbtTypeServiceProfileName
<AtrbtTypeId(1-255)>] [vlan-classf-bit-align
{msbShift|lsb}][alrmAaaSwitchoverRetryFailThrshld(1-250)>]>
Command
Modes
Global command mode
NOTE
You can display configuration information for global RADIUS parameters. For details, refer to
Section 3.4.12.9.2.3
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config)# radius <[accessreq-retries <retransmissions>] [accessreq-interval <timeout>]
[nasid <nas-identifier>] [timezone-offset <time-offset(0-86400)>] [mtu <framed mtu
size(1020-2000)>] [RadiusAtrbtTypeServiceProfileName <AtrbtTypeId(1-255)>]
[
alrmAaaSwitchoverRetryFailThrshld(1-250)>] [vlan-classf-bit-align {msbShift|lsb}]>