User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 269 System Manual
3.4.12.9.1.4 Switching between the Primary and Alternate Servers
Run the following command to switch between servers:
npu(config-aaa)# aaaSwitchOver
This command is applicable only when aaa redundancy is enabled.
If you execute this command when the active server is the primary server, the unit
will attempt connecting to the alternate server, and vice versa.
3.4.12.9.1.5 Terminating the AAA Client Configuration Mode
Run the following command to terminate the AAA client configuration mode:
npu(config-aaa)# exit
Command
Syntax
npu(config-aaa)# no alternate-serveraddr
Privilege
Level
10
Command
Modes
AAA client configuration mode
Command
Syntax
npu(config-aaa)# aaaSwitchOver
Privilege
Level
10
Command
Modes
AAA client configuration mode
Command
Syntax
npu(config-aaa)# exit
Privilege
Level
10