User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 268 System Manual
3.4.12.9.1.3 Restoring the Default Value of the Alternate Server
Run the following command to restore the default value (0.0.0.0) 0f the alternate
server:
npu(config-aaa)# no alternate-serveraddr
[alternate-serverad
dr <ipv4addr>]
Denotes IPv4 address of
the alternate (secondary)
AAA server.
0.0.0.0 means no alternate
server.
Must be set to a valid IP
address if aaaRedundancy
is enabled.
Optional 0.0.0.0 Valid IP
Address
[rad-sharedsecret
<string>]
Denotes the shared secret
between the AAA client and
the AAA server(s).
Optional default String (1 to 49
characters)
[aaaRedundancy
{Enable|Disable}]
Indicates whether AAA
server redundancy is
supported.
If enabled, the ASN-GW will
try switching to the alternate
server if the primary server
does not respond, and vise
versa.
If enabled - the ip-address
of the active server (primary
or alternate) cannot be
modified.
Optional Disable
 Enable
 Disable
[rad-CallingStationI
d {Binary | UTF-8}]
The format of the MAC
address used to define the
Calling Station ID
Optional UTF-8
 Binary
 UTF-8
Command
Modes
AAA client configuration mode
IMPORTANT
The alternate server cannot be cleared (restored to the default value) id aaaRedundancy is
enabled.