User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 266 System Manual
client-alias: default
src-intf: Bearer
After enabling the AAA client configuration mode you can execute any of the
following tasks:
 Configure the AAA client parameters (refer to Section 3.4.12.9.1.2)
 Restore the default configuration of the Alternate Server (refer to
Section 3.4.12.9.1.3)
 Switch between the Primary and Alternate Servers (refer to
Section 3.4.12.9.1.4)
 Terminate the AAA client configuration mode and return to the global
configuration mode (refer to Section 3.4.12.9.1.5).
3.4.12.9.1.2 Configuring Parameters for the AAA Client
After enabling the AAA client configuration mode, run the following command to
configure the parameters for the AAA client:
Command
Syntax
npu(config)# aaa-client <client-alias>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<client-alias> Denotes the client-alias of the
AAA client for which the
configuration mode is to be
enabled.
In the current release a single
AAA client is supported, with
client-alias “default”.
Mandatory N/A default
Command
Modes
Global configuration mode