User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 265 System Manual
3.4.12.9 Configuring the AAA Client Functionality
The AAA client functionality enables configuration of one RADIUS client. The
RADIUS client encapsulates the messages destined for the AAA server in RADIUS
messages or decapsulates messages sent by the AAA server for the MS.
In addition, you can also configure certain RADIUS parameters such as the NAS
ID and the time zone offset that are applicable for all AAA clients. In the current
release a single AAA client is supported.
This section describes the commands for:
 “Managing AAA Client Configuration” on page 265
 “Managing Global RADIUS Configuration Parameters” on page 271
3.4.12.9.1 Managing AAA Client Configuration
1 Enable the AAA client configuration mode (refer to Section 3.4.12.9.1.1)
2 You can now execute any of the following tasks:
» Configure the AAA client parameters (refer to Section 3.4.12.9.1.2)
» Restore the default configuration of the Alternate Server (refer to
Section 3.4.12.9.1.3)
» Switch between the Primary and Alternate Servers (refer to
Section 3.4.12.9.1.4)
» Terminate the AAA client configuration mode (refer to Section 3.4.12.9.1.5)
In addition, you can, at any time, display the AAA client configuration information
(refer to Section 3.4.12.9.1.6). The AAA client cannot be deleted.
3.4.12.9.1.1 Enabling the AAA Client Configuration Mode
To configure the AAA client parameters, first enable the AAA client configuration
mode. Run the following command to enable the AAA client configuration mode.
npu(config)# aaa-client <client-alias>
The system is supplied with a pre-configured AAA client with the following
properties that cannot be modified:
To configure the AAA client: