User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 398 System Manual
 AU management procedures
This section describes the commands to be used for:
 “Configuring the Log Severity Level” on page 398
 “Displaying Configuration Information for Module-level Logging” on page 400
 “Disabling Module-level Logging” on page 401
3.4.13.2.1 Configuring the Log Severity Level
You can configure the severity level for logs to be generated for each module. This
means that if an event occurs for a module for which the severity level is equal to
or higher than the configured level, a log is generated. The following are the
severity levels (highest to lowest) that can be configured for each module:
 Alert
 Error
 Information
To specify the severity level for each module for which logs are to be created, run
the following command:
npu(config)# log level
[{StartupMgr|SWDownload|FaultMgr|PerfMgr|ShelfMgr|SIGASN|UserIF|AU
Mgr}] {ALERT|ERROR|INFO}
The parameters in this command correspond to the system modules/procedures
listed in the following table:
IMPORTANT
By default, logging is enabled for all modules, and the severity level is Error. The severity levels
recorded in 4Motion log messages are defined in RFC 3164.
Table 3-24: Modules for which Logging can be Enabled
Parameter Refers to...
StartupMgr System startup procedures
SWDownload Software upgrade procedures