User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 262 System Manual
3.4.12.8.4.2 Terminating the VLAN Service Interface Configuration Mode
Run the following command to terminate the vlan service interface configuration
mode:
npu(config-srvcif-vlan)# exit
3.4.12.8.4.3 Terminating the QinQ Service Interface Configuration Mode
Run the following command to terminate the QinQ service interface configuration
mode:
npu(config-srvcif-QinQ)# exit
3.4.12.8.5 Deleting a Service Interface
You can, at any time, run the following command to delete service interface:
npu(config)# no srvc-intf [<intf-alias>]
Command
Syntax
npu(config-srvcif-vlan)# exit
Privilege
Level
10
Command
Modes
VLAN Service interface configuration mode
Command
Syntax
npu(config-srvcif-QinQ)# exit
Privilege
Level
10
Command
Modes
QinQ Service interface configuration mode
NOTE
A Service Interface cannot be deleted if it is assigned to any Service Group.
A QinQ Service Interface cannot be deleted if it is assigned to a Service Flow (with a VPWS-QinQ
Service Group). For details refer to
“Configuring Service Flows” on page 314.