User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 378 System Manual
Run the following command to restore the default value of the IP protocol
parameters: npu(config-hotlining-filter-rule)# no ip-protocol.
3.4.12.13.2.4.8Terminating the Filter Rule Configuration Mode
Run the following command to terminate the filter rule configuration mode:
npu(config-hotlining-filter-rule)# exit
3.4.12.13.2.5 Deleting Filter Rules
Run the following command to delete a filter rule of the profile:
npu(config-hotlining-profile)# no filter-rule <filter-rule-name>
Command
Syntax
npu(config-hotlining-filter-rule)# no ip-address
npu(config-hotlining-filter-rule)# no source-port
npu(config-hotlining-filter-rule)# no destination-port
npu(config-hotlining-filter-rule)# no dscp-range
npu(config-hotlining-filter-rule)# no ip-protocol
Privilege
Level
10
Command
Modes
hotlining filter rule configuration mode
Command
Syntax
npu(config-hotlining-filter-rule)# exit
Privilege
Level
10
Command
Modes
hotlining filter rule configuration mode
Command
Syntax
npu(config-hotlining-profile)# no no filter-rule <filter-rule-name>