User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 376 System Manual
3.4.12.13.2.4.5Configuring DSCP Range Parameters for the Filter Rule
After enabling the filter rule configuration mode, run the following command to
configure the DSCP parameters of the filter rule:
npu(config-hotlining-filter-rule)# dscp start <dscp-value(0-63)> stop
<dscp-value(0-63)>
If you do not configure DSCP parameters for the filter rule, the default values will
be used, meaning that DSCP is ignored.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
start
<port-number(0-65
535)>
The minimum value of
destination TCP/UDP port
range
Optional 0 0-65535
stop
<port-number(0-65
535)>
The maximum value of
destination TCP/UDP port
range
Optional 65535 0-65535
Command
Modes
hotlining filter rule configuration mode
Command
Syntax
npu(config-hotlining-filter-rule)# dscp start <dscp-value(0-63)> stop
<dscp-value(0-63)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
start
<dscp-value(0-63)
>
The minimum value of DSCP Optional 0 0-63
stop
<dscp-value(0-63)
>
The minimum value of DSCP Optional 63 0-63