User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 375 System Manual
3.4.12.13.2.4.4Configuring Destination Port Range Parameters for the Filter Rule
After enabling the filter rule configuration mode, run the following command to
configure the destination port parameters of the filter rule:
npu(config-hotlining-filter-rule)# destination-port start
<port-number(0-65535)> stop <port-number(0-65535)>
If you do not configure destination port parameters for the filter rule, the default
values will be used, meaning that destination port is ignored.
Command
Syntax
npu(config-hotlining-filter-rule)# source-port start <port-number(0-65535)>
stop <port-number(0-65535)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
start
<port-number(0-65
535)>
The minimum value of source
TCP/UDP port range
Optional 0 0-65535
stop
<port-number(0-65
535)>
The maximum value of
source TCP/UDP port range
Optional 65535 0-65535
Command
Modes
hotlining filter rule configuration mode
Command
Syntax
npu(config-hotlining-filter-rule)# destination-port start
<port-number(0-65535)> stop <port-number(0-65535)>
Privilege
Level
10