User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 374 System Manual
If you do not configure IP address parameters for the filter rule, the default IP
address (0.0.0.0) and subnet mask (0.0.0.0) will be used, meaning that IP address
is ignored.
3.4.12.13.2.4.3Configuring Source Port Range Parameters for the Filter Rule
After enabling the filter rule configuration mode, run the following command to
configure the source port parameters of the filter rule:
npu(config-hotlining-filter-rule)# source-port start <port-number(0-65535)>
stop <port-number(0-65535)>
If you do not configure source port parameters for the filter rule, the default
values will be used, meaning that source port is ignored.
Command
Syntax
npu(config-hotlining-filter-rule)# ip-address <ipV4Addr> [<netMask>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ipV4Addr> If direction is downlink then
this is the downlink Source IP
Address.
If direction is uplink then this
is the uplink Destination IP
Address
255.255.255.255 means not
applicable (ignore this
condition).
Optional 255.255.
255.255
ip address
[<netMask>] Defines Subnet Mask
associated with the
configured IP address.
Optional 255.255.
255.255
subnet mask
Command
Modes
hotlining filter rule configuration mode