User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 371 System Manual
3.4.12.13.2.3 Configuring the HTTP Redirect URL for the Profile
After enabling the hot-lining profile configuration mode, run the following
command to configure the HTTP redirect address (if required):
npu(config-hotlining-profile)# redirect-address <http-redirect-address>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
set profile {
enabled | disabled
}
Defines whether the profile is
enabled or disabled.
Optional disabled
 enabled
 disabled
Command
Modes
hot-lining profile configuration mode
Command
Syntax
npu(config-hotlining-profile)# redirect-address <http-redirect-address>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
redirect-address
<http-redirect-addr
ess>
The HTTP redirect URL to be
used by uplink filter rules with
redirect action (see
Section 3.4.12.13.2.4)
Redirection location to be
used in Http-Redirection
message.
Optional N/A URL in ASCII
string format.
Command
Modes
hot-lining profile configuration mode